Mahindra XUV700 2021 Diagnostic Manual page 109

Table of Contents

Diagnostic Manual

XUV700 (Diesel)

• GO TO STEP 7

STEP 7 — CHECK FOR CAN HIGH & LOW CIRCUIT SHORT TO BATTERY POSITIVE

PRE CONDITION

• Ignition ON

TEST PROCEDURE

• Measure the voltage between pin 14 of DLC connector (C 555) and battery ground

• Measure the voltage between pin 6 of DLC connector (C 555) and battery ground

CRITERIA

• Voltage = Battery voltage

• Suspect CAN wires/ ECUs internally short

circuit to battery supply

• Remove ECUs in CAN network one by one

and identify the ECU having internal short

to battery supply

• If the ECUs are OK, identify the harness

which is having internal short to battery

supply

• Identify and replace the faulty wiring

harness/ ECUs

• Check and confirm that ECUs are able to

communicate with i-SMART

• Clear the DTC and verify

The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by

the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present

document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of

ACTION TO BE TAKEN

UICU

NOT OK

• Suspect CAN wires/ ECU's internally short