Mahindra XUV700 2021 Diagnostic Manual page 73

Diagnostic Manual
XUV700 (Diesel)
B2F47–00
B2F4F-00
B2F43–00
B2F42–00
B2F50–00
U1517–00
STEP 1 – PERFORM KEY CHECK TO WRITE TAG CODE
PRE CONDITION
• Turn ON ignition
TEST PROCEDURE
• Connect i-SECURE dealer tool, select the appropriate platform. Select no of keys available
and perform the key check process.
Always use i-SECURE + V4.0 and above for any security components ECU
programming in "XUV 7OO"
ACCEPTANCE CRITERIA
• Key check should pass successfully
• Tag code written at the end of key check
• Turn OFF ignition for 2 minutes
• After 2 minutes turn ignition ON and make sure
previously set check lamps are cleared
• And crank the engine to start the vehicle
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by
the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2021 Mahindra & Mahindra Ltd.
UICU
Refer Key checking procedure
ACTION TO BE TAKEN
OK
Immobilizer ID not programmed / Invalid
EMS ECU ID not programmed/Invalid
TXP ID table empty
Wrong TXP
SK not Programmed/INVALID
Immo variant code error
• Contact TEKliner for further
assistance
MAN-01065
OCT - 2021/Rev 1
NOT OK
73