Mahindra XUV700 2021 Diagnostic Manual page 50

Diagnostic Manual
XUV700 (Diesel)
13.5.2 DIAGNOSTIC PROCEDURE
STEP 1 – CHECK TAG FEATURE CODING
PRE CONDITION
• Turn ON the ignition
TEST PROCEDURE
• Connect i-SMART diagnostic tool, see whether UICU is detecting
• Open UICU read ECU tab and check TAG feature code
ACCEPTANCE CRITERIA
• TAG feature code should be "0X00000000020201"
• Connect i-SECURE tool and enter platform home
page
• Select No of keys available and perform key check
• If any error observed while performing key check,
Contact TEKline for further assistance
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document, are
50
prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd., will
amount to unauthorized use and shall be liable for penalty/prosecution© 2021 Mahindra & Mahindra Ltd.
UICU
ACTION TO BE TAKEN
OK NOT OK
• Use i-SECURE programming tool
and enter platform home page &
perform key check to write correct
TAG code in the UICU for the
available type key.
checking procedure
• After Tag code writing, Reset ignition
for 2 minutes and confirm whether
the issue is resolved
• If the DTC still present, Replace
UICU with new one and perform
UICU assignment.
MAN-01065
OCT - 2021/Rev 1
Refer Key