Heater Unit And Blower Assembly - Mitsubishi Lancer Evolution-VII Workshop Manual

55-28
HEATER, AIR CONDITIONER AND VENTILATION

HEATER UNIT AND BLOWER ASSEMBLY

REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operations
Refrigerant Draining and Refilling (Refer to P.55-16, 19.)
D
Coolant Draining and Refilling (Refer to GROUP 14 – On - vehicle Service.)
D
Instrument Panel Removal and Installation (Refer to GROUP 52A – Instrument Panel.)
D
Front Seat Removal and Installation (Refer to GROUP 52A – Front Seat.)
D
Floor Console Removal and Installation (Refer to GROUP 52A – Floor Console.)
D
Floor Carpet Removal and Installation
D
- Pipe coupling
O-ring
4, 5
A/C compressor oil:
SUN PAG 56
Heater unit and blower assembly
removal steps
1. Steering shaft attachment bolt
2. Front deck crossmember
3. Heater hose connection
4. Suction pipe connection
AA"
6
7
2
1
AA"
REMOVAL SERVICE POINTS
AA" SUCTION PIPE AND LIQUID PIPE B
DISCONNECTION
To prevent the entry of dust or other foreign bodies, plug
the dismantled hose and the nipples of the expansion valves.
Caution
As the compressor oil and receiver are highly moisture
absorbent, use a non-porous material to plug the hose
and nipples.
-
Heater Unit and Blower Assembly
3
5
4
12 ± 2 N·m
5. Liquid pipe B connection
6. Center duct
7. Heater unit
8. Intake duct
9. Blower assembly
8
9