Omron FZ5 Series Hardware Setup Manual page 92

3 Configuration
Component Names and Functions
(1)
(2)
(3)
(8)
(4)
(6)
Connector name
(1) POWER LED
(2) RUN LED
(3) ERROR LED
(4) I/O connector (con-
trol lines, data lines)
(5) Camera connector
(6) Power
(7) Monitor connector
(analog RGB)
(8) RS-232C connector
(9) USB connector
(10) Ethernet connector
3 - 30
(9)
(7)
(10)
(5)
Lit while power is ON.
Lit while the layout turned on output setting is displayed.
Lit when an error has occurred.
Connect the controller to external devices such as a sync sensor.
Connect cameras.
Connect a DC power supply.
Wire the power supply unit independently of other devices.
After wiring, replace the terminal cover.
Connect a monitor.
Connect an external device such as a personal computer.
Connect a track ball, mouse and USB flash drive. A total of four USB ports are
provided and any of them can be used.
However, when connecting two USB memories, do not connect them to adjacent
ports. Doing so may cause the USB memories to come into contact, resulting in
malfunction or damage.
Connect Ethernet device.
Ethernet port and EtherNet/IP port are sharing use.
Description
Vision System FZ5 series Hardware Setup Manual (Z423)