Omron FZ5 Series Hardware Setup Manual page 235

 [Input]
Applicable signals/
• No.4 pin:
Connect the COMIN1 terminal when using these signals.
Input voltage
ON current
ON voltage
OFF current
OFF voltage
ON delay
OFF delay
Maximum frequency response
*1. ON current and ON voltage:
Those mean the current or voltage to turn ON from OFF. The ON voltage value is the potential difference
between COMIN and each input terminal.
*2. OFF current and OFF voltage:
Those mean the current or voltage to turn OFF from ON. The OFF voltage value is the potential difference
between COMIN and each input terminal.
 [Output]
Applicable signals/
• No.15 to 19 pin:
Connect the COMOUT0 terminal when using these signals.
• No.48, 49, 51 to 57 pins:
Connect the COMOUT2 terminal when using these signals.
• No.58 to 66 pins:
Connect the COMOUT3 terminal when using these signals.
Item
Output voltage
Load current
ON residual voltage
OFF leakage current
*1. The current value must be the specified load current or lower. Exceeding the specified current value may
cause damage of the output circuit.
 [Output]
Applicable signals/
• No.20 to 23 pins:
Connect the COMOUT1 and COMIN0 terminals when using these signals.
Item
Output voltage
Load current
ON residual voltage
OFF leakage current
*1. The current value must be the specified load current or lower. Exceeding the specified current value may
cause damage of the output circuit.
Vision System FZ5 series Hardware Setup Manual (Z423)
Item
12 to 24 VDC ±10%
5 mA min.
*1
*1 8.8 V min.
0.5 mA max.
*2
0.8 V max.
*2
0.1 ms max.
0.1 ms max.
4 KHz
12 to 24 VDC ±10%
45 mA max.
*1
2 V max.
0.2 mA max.
12 to 24 VDC ±10%
45 mA max.
*1
2 V max.
0.2 mA max.
6 I/O Interface
Specifications
Specifications
Specifications
6
6 - 11