Omron FZ5 Series Hardware Setup Manual page 214

5 Setup and Wiring
Accessibility for Operation and Maintenance
When you connect the cable to the Sensor Controller, secure the minimum bending radius of the cable
or cable connector.
Connector length
Minimum bending radius
Installation in a Control Panel
• Make sure to tighten all installation screws securely.
• To keep proper air flow, keep the top of the FH Sensor Controller 50 mm or more apart from other
devices. Install the FH Sensor Controller with a clearance of 30 mm on the right and left side, and 15
mm for rear planes. The clearance is required for installing multiple units side-by-side. For the back
mounting, the back-side clearance of 15 mm is nor required.
 Mounting the base of the Sensor Controller (Floor mounting)
Clearance: 30 mm
22
• Recommended tightening torque: 0.54 N
• The tolerance:
5 - 44
Camera Cable
Right-angle Camera Cable
Bend resistant Camera Cable
Bend resistant Right-angle
Camera Cable
Long-distance Camera Cable
Long-distance Right-angle
Camera Cable
Clearance: 50 mm
Clearance: 15 mm
Clearance: 30 mm
Four, M4 depth 6.5
100
±
0.2 mm
Name Model
FZ-VS3
FZ-VSL3
FZ-VSB3
FZ-VSLB3
FZ-VS4
FZ-VSL4
• m to 0.6 N • m
Vision System FZ5 series Hardware Setup Manual (Z423)
Minimum
Connector
bending
length
radius
69 mm 30 mm
78 mm 42 mm