Omron FZ5 Series Hardware Setup Manual page 69

Sensor Controller Series
Type
Sensor Controller Model
Serial Communication
Ethernet Protocol
I/F
Communi-
cation
EtherNet/IP Communica-
tion
PROFINET Communica-
tion
EtherCAT Communication
Parallel I/O
External
Interface
Encoder Interface
Monitor Interface
USB I/F
SD Card I/F
Main
Ethernet
Indicator
Lamps
SD Card
EtherCAT
Supply Voltage
Vision System FZ5 series Hardware Setup Manual (Z423)
FH-3000 Series
Standard Controller (4 cores)
FH-3050 FH-3050-10 FH-3050-20
RS-232C × 1
Non-procedure (TCP/UDP)
1000BASE-T × 2
1000BASE-
T × 1
Yes (Target/Ethernet port)
• Yes (Slave/Ethernet port)
• Conformance class A
Yes (slave)
12 inputs/31 outputs:
Use 1 Line.
Operation mode: Except Multi-line random-trigger mode.
17 inputs/37 outputs:
Use 2 Lines.
Operation mode: Multi-line random-trigger mode.
14 inputs/29 outputs:
Use 3 to 4 Lines.
Operation mode: Multi-line random-trigger mode.
19 inputs/34 outputs:
Use 5 to 8 Lines.
Operation mode: Multi-line random-trigger mode.
Input voltage: 5 V ± 5%
Signal: RS-422A Line Driver Level
Phase A/B/Z: 1 MHz
DVI-I output (Analog RGB & DVI-D single link) × 1
USB 2.0 host × (BUS Power: 5 V/0.5 A per port)
SDHC × 1
POWER: Green
ERROR: Red
RUN: Green
ACCESS: Yellow
NET RUN: NET RUN1: Green
Green
LINK/ACT1: Yellow
LINK/ACT:
NET RUN2: Green
Yellow
LINK/ACT2: Yellow
SD POWER: Green
SD BUSY: Yellow
ECAT RUN: Green
LINK/ACT IN: Green
LINK/ACT OUT: Green
ECAT ERR: Red
20.4 VDC to 26.4 VDC
3 Configuration
FH-1000 Series
Standard Controller (2 cores)
FH-1050 FH-1050-10 FH-1050-20
1000BASE-T × 2
1000BASE-
T × 1
NET RUN: NET RUN1: Green
Green
LINK/ACT1: Yellow
LINK/ACT:
NET RUN2: Green
Yellow
LINK/ACT2: Yellow
3
3 - 7