Omron FZ5 Series Hardware Setup Manual page 275

Pin Layout
 10Base-T and 100Base-TX
 1000Base-T
Wire
Describes the connection processing to connector hood of shield as the following. The connection pro-
cessing is changed according to the transfer speed.
• 10BASE-T/100BASE-TX
Connects the shield of its both ends to each of connector hoods. Connects the shield of only one side
of switching hub to connector hoods.
• 1000BASE-T
Connects the shield of its both ends to each of connector hoods.
Vision System FZ5 series Hardware Setup Manual (Z423)
Connector pin Signal name
1 Transmission data +
2 Transmission data -
3 Reception data +
4 Not used.
5 Not used.
6 Reception data -
7 Not used.
8 Not used.
Connector pin Signal name
1 Communication data DA +
2 Communication data DA -
3 Communication data DB +
4 Communication data DC +
5 Communication data DC -
6 Communication data DB -
7 Communication data DD +
8 Communication data DD -
6 I/O Interface
Abbr. Signal direction
TD + Output
TD - Output
RD + Input
---
---
RD - Input
---
---
Abbr. Signal direction
BI_DA + Input/output
BI_DA - Input/output
BI_DB + Input/output
BI_DC + Input/output
BI_DC - Input/output
BI_DB - Input/output
BI_DD + Input/output
BI_DD - Input/output
---
---
---
---
6
6 - 51