Omron FZ5 Series Hardware Setup Manual page 72

3 Configuration
Connector name
(L) Power supply ter-
minal connector
(A)
(B)
(C)
(D)
(E)
(F)
(K)
(L)
(M)
(N)
LED name
(A) POWER LED
(B) ERROR LED
(C) RUN LED
(D) ACCESS LED
(E) SD POWER LED
(F) SD BUSY LED
(G) EtherCAT RUN
LED
(H) EtherCAT
LINK/ACT IN LED
(I) EtherCAT
LINK/ACT OUT
LED
(J) EtherCAT ERR
LED
(K) Ethernet NET
RUN1 LED
(L) Ethernet
LINK/ACT1 LED
(M) Ethernet NET
RUN2 LED
(N) Ethernet
LINK/ACT2 LED
3 - 10
Connect a DC power supply. Wire the FH Sensor Controller independently on other
devices.
Wire the ground line. Be sure to ground the FH Sensor Controller alone.
Use an attachment power terminal (male) for installation.
For details, refer to 5-3-2 FH-1000/2000/3000/5000 Series on page 5-8.
(G)
(H)
(I)
(J)
Lit while power is ON.
Lit when an error has occurred.
Lit while the layout turned on output setting is displayed.
Blinks while the internal nonvolatile memory is accessed.
Lit while power is supplied to the SD memory card and the card is usable.
Blinks while the SD memory card is accessed.
Lit while EtherCAT communications are usable.
Lit when connected with an EtherCAT device, and blinks while performing commu-
nications.
Lit when connected with an EtherCAT device, and blinks while performing commu-
nications.
Lit when EtherCAT communications have become abnormal.
Lit while Ethernet communications are usable.
Lit when connected with an Ethernet device, and blinks while performing communi-
cations.
Lit when Ethernet communications are usable.
Lit when connected with an Ethernet device, and blinks while performing communi-
cations.
Description
Description
Vision System FZ5 series Hardware Setup Manual (Z423)