Omron FZ5 Series Hardware Setup Manual page 18

Safety Precautions
Never connect the AC power supply with this product. When the AC power
supply is connected, it causes the electric shock and a fire.
A lithium battery is built into the Sensor Controller and may occasionally
combusted, explode, or burn if not treated properly. Dispose of the Sensor
Controller as industrial waste, and never disassemble, apply pressure that
would deform, heat to 100°C or higher, or incinerate the Sensor Controller.
Since camera that can be connected with this product emits a visible light
that may have an adverse effect on the eyes, do not stare directly into the
light emitted from the LED. If a specular object is used, take care not to allow
reflected light enter your eyes.
Do not touch the terminals while the power supply is ON.
Doing so may result in electrical shock.
Please take external safety measures so that the system as a whole should
be on the safe side even if a failure of a sensor controller or an error due to
an external factor occurred. An abnormal operation may result in serious
accident.
Please take fail-safe measures on your side in preparation for an abnormal
signal due to signal conductor disconnection and/or momentary power inter-
ruption. An abnormal operation may result in a serious accident.
CAUTION
Danger of burns. Do not touch the case while the LED is ON or just after
power is turned OFF, since it remains extremely hot.
16
Vision System FZ5 series Hardware Setup Manual (Z423)