Table of Contents
Advertisement
• Gateway: Enter gateway address of the managed switch. Press Save and
Reboot to apply changes. This field is only available if the Mode is set to Static.
The default Gateway for LAN1 is 192.168.1.1.
• Enable Discovery: This mode allows the AVoIP Matrix Controller to be
"discovered" on a network using the Gefen Syner-G Software Suite. Disabling
this mode prevents the discovery of the AVoIP Matrix Controller on the network.
The Default setting is Enabled.
• Show Me: When "Show Me" feature is enabled, the Power LED on the front
panel will flash Blue. This quickly identifies a unit and is useful when multiple
units are being used. The default setting is Disabled.
• Discovery Read Only: This mode permits the discovery of the Matrix Controller
on the network. When Disabled, the IP settings, description and other settings
for the AVoIP Matrix Controller can be changed using the Syner-G Software
Suite. The Default setting is Disabled.
• Product Description: The default device name will be displayed in the Description
field on Gefen Syner-G Software Suite. Click in the Description field and change to
the desired name and press save. The default name is GF-AVIP-MC.
• mDNS Host Name: The mDNS Host Name will be displayed in the field. Click in
the field and change to the desired name and press Save. A reboot is required to
apply changes. The default mDNS Host Name is AVIP-MC.local/
Click on the TCP/UDP button highlighted in red to access the TCP and UDP settings page.
WebGUI Control Page
Discovery Protocol Settings
TCP/UDP (Sub Page)
39
Advertisement
Table of Contents
