Table of Contents
Advertisement
Upgrade All (Transmitter/Receiver)
To update all Transmitters and Receivers, click the Choose File button to open the file
selection window and then select an appropriate batch firmware update file in a "*.7z"
format. (For ex. AVoIP_3.17.7z). The update process may take more than 10 minutes to
complete. Once the firmware has been uploaded, the devices will reboot.
NOTE: The firmware package can be downloaded from the Gefen's downloads
page from
https://www.gefen.com/downloads-resources/
NOTE: Receiver page will list units running FW <2.x including transmitters and will
be appeared disconnected.
When experiencing of units rebooting when introducing a mix set of firmware version
units of <FW 2.x and FW 3.x, units will cause link problems due to incompatibility. You
will need to manually route the problematic RX to an unused channel or Factory Reset the
AVoIP unit before an update is performed.
Any duplicate device IP or Channel conflict will be listed in the end of the I/O list.
Firmware update will not be applied until these conflicts are resolved. Select the devices
in the I/O list and perform an AutoAssign or Factory Reset each device.
Before attempting a Firmware Upgrade to AVoIP the units, the Video Port of the controller
must be configured in the same IP range as the AVoIP units.
When a firmware update is in progress, this progress icon
will be displayed adjacent to the unit that is updating. This
only applies to units running above FW3.x.
Upgrade Procedure
1.
Configure the Video Port of the controller to Auto IP
and reboot.
2.
Once all AVoIP units are discovered, Perform an
Upgrade ALL function.
3.
Perform an AutoAssign to the desired IP range.
4.
Make sure to configure the Video Port of the controller
in the desired IP range as the AVoIP units.
For an existing install using EXT-CU-LAN:
1.
Within EXT-CU-LAN WEBGUI, perform a Save Configuration to back-up the
configuration. Refer to EXT-CU-LAN manual for details.
2.
Disconnect EXT-CU-LAN from the network.
3.
Configure the Video Port of GF-AVIP-MC to the same IP used for EXT-CU-LAN.
4.
Once all AVoIP units are discovered, perform an Upgrade ALL function.
5.
Perform an I/O Devices Upload Config and browse for the EXT-CU-LAN back-up
configuration *.xml file.
WebGUI Control Page
AVoIP Batch Update
37
Advertisement
Table of Contents
