Table of Contents
Advertisement
No. Wire
colour
8
red
Table 3: Assignment control elements
Insulate the wires not required against contact.
Do not plug the control lines into the printed circuit board
until they have been wired.
4.5
Settings
The ExitSafe-S control module has six DIP switches to
set the functions listed in Table 4. These settings should
be confi gured before installing the ExitSafe.
For automatic retraction of the blind at a low charge
level, set DIP switch 3 to "On".
DIP switches 1 to 6
Designation Assignment
+
elero GmbH
+ 8.4 to 12 V DC supply of
control elements
(Default setting:
All 6 DIP switches in
the OFF position.
EN | 17
Advertisement
Table of Contents
