Udp Configuration; Rs-232 Configuration - Nice GEFEN GF-AVIP-MC User Manual

Avoip matrix controller

Table of Contents

Menu System Summary

• Configure the desired control system for UDP.

• Click the Network Settings tab within the web interface and do the following.

» Click the Enabled button next to UDP Access.

» Enter the UDP listening port in the UDP Port field. The default UDP

listening port is 50007.

» Click the Enabled button next to Remote UDP Access. This feature

only needs to be enabled if feedback to the matrix is required.

Otherwise, this feature can be disabled.

» If enabling Remote UDP Access, enter the remote UDP IP address

in the Remote UDP IP Address field. This IP address should be the

same as the control system. The default IP address is 192.168.1.255.

» If enabling Remote UDP Access, enter the remote UDP listening port

in the Remote UDP Port field. The default remote UDP listening port

is 50008.

» Click the Save button and reboot the controller.

• Configure the RS-232 port to the following settings. Note that Only TxD, RxD

and GND pins are used.

• The Default Baud rate Settings: 115200, Data bits 8, Parity None, Stop bits

1, Hardware flow control None

» Connect to the RS-232 port.

» Type #help for a list of commands, or refer to the tables on the

following pages.

UDP Configuration

Table of Contents