Table of Contents
Advertisement
General UDP Commands
System Settings (cont.)
#REBOOT
Reboot the unit.
Syntax
Parameters
Example
Example Feedback
Input Status
#GETS_INPUT_SIGNAL
Get active signal status of one or all inputs.
Syntax
Parameters
Example
Example Feedback
#GETS_INPUT_HPD
Get HPD status of one or all inputs.
Syntax
Parameters
Example
Example Feedback
#REBOOT
UNIT WILL REBOOT SHORTLY
#GETS_INPUT_SIGNAL PARAM1
PARAM1 = 0, 1 ~ N
0 - ALL INPUTS
1 ~ N = TX CHANNEL
#GETS_INPUT_SIGNAL 0
#GETS_INPUT_SIGNAL 1
RESPONSE = N, Y
N = NO CLOCK SIGNAL PRESENTS AT HDMI INPUT PORT
Y = VALID CLOCK SIGNAL DETECTED AT HDMI INPUT PORT
INPUT_SIGNAL 1 Y 5 Y 10 N
INPUT_SIGNAL 1 Y
#GETS_INPUT_HPD PARAM1
PARAM1 = 0, 1 ~ N
0 - ALL INPUTS
1 ~ N = TX CHANNEL
#GETS_INPUT_HPD 0
#GETS_INPUT_HPD 1
RESPONSE = L, H
L = HPD LOW
H = HPD HIGH
INPUT_HPD 1 H 5 L 10 H
INPUT_HPD 1 H
50
Advertisement
Table of Contents
