Table of Contents
Advertisement
• Video Wall Bezel: This section is used to define the physical dimensions of
each display being used in the video wall. Accurate measurements are needed
of the monitor's outer frame (OW, OH) and the video screen (VW, VH). The
measurements may be made using any unit of measurement (inches, mm, cm,
etc.) as long as ALL measurements in the same wall are made using the exact
same units and the numbers are integers.
» OW (Outer Width): This is the horizontal measurement of the display's
outer case.
» OH (Outer Height): This is the vertical measurement of the display's
outer case.
» VW (Video Width): This is the horizontal measurement of the display's
video screen.
» VH (Video Height): This is the vertical measurement of the display's
video screen.
» Rotate: Set the rotation of the video output to 0, 180, or 270 degrees.
NOTE: All monitors in a video wall should be identical and have the same dimensions.
• TV Wall Assignments: Each rectangle in this section represents a single display
within the defined video wall. From the Receiver list, drag & drop a receiver to
assign to a specific display. Once assigned, the window will be colored brown. If
no receiver is attached to a specific display, the window output will be in blue.
NOTE: A receiver should not be assigned to more than one display.
• Receiver OSD Toggle: This will toggle the Receivers Video Wall OSD ID to
appear on the list indicated by the ID in the parenthesis as well as output the
VW ID to each Receiver. This will help simplify the configuration for the video
wall layout by matching the VW ID to the desired location.
WebGUI Control Page
22
Advertisement
Table of Contents
