Table of Contents
Advertisement
» RS232 Settings: Click the RS-232 Settings button to access the RS-
232 settings of the device. Press the Save button and perform a device
reboot to apply settings.
» USB Settings: Click the USB Settings button to access the USB
settings of the device. Press the Save button and perform a device
reboot to apply settings.
This process is used to perform a batch assignment of Network and Channel ID settings.
This will Auto Assign the IP address based on a specific given starting IP address.
• Starting IP: Enter the starting IP address to use. This information is used by the
Auto Assign button.
• Subnet Mask: Select from the drop down menu the subnet mask address.
• Gateway: Enter the gateway address in this field.
• Select All: Selects all devices in the Transmitter or Receiver page.
• Deselect All: Click this button to deselect all devices in the Transmitter or
Receiver page.
• Auto Assign: Click this button to auto-assign the IP address, ID and Channel
of the selected device(s). This button should only be used if there are devices
outside of the IP range or conflicting Channel ID numbers.
• Delete Device: Click this button to delete any or all disconnected devices.
IMPORTANT: AVoIP units running Firmware <2.x will all appear in the Receiver
I/O page which includes Transmitters. Firmware update is is required. Refer to
Firmware Upgrade
IMPORTANT: Duplicate device IP or Channel conflict will be listed in the end of the
I/O list. Firmware update will not be applied until these conflicts are resolved. Select
the devices in the I/O list and perform an AutoAssign or Factory Reset each device.
WebGUI Control Page
Auto Assign Process
section, pg. 36.
27
Advertisement
Table of Contents
