Table of Contents
Advertisement
This mode is used when the KVM over IP products are connected to a separate
(dedicated) managed switch.
Two CAT-5e (or better) cables will be required to connect the Matrix Controller. If a single
switch will be connecting Gefen KVM over IP products in addition to your other network
devices.
1.
Connect a shielded CAT-5e (or better) cable from each of the Gefen KVM over IP
units to a managed switch. Refer to the User Manual(s) for the Gefen KVM over IP
units to obtain the network requirements.
2.
Connect a CAT-5e (or better) cable from the LAN 1 port on the Matrix Controller to
the network switch.
3.
Connect a secondary CAT-5e (or better) cable from the LAN 2 port on the Matrix
Controller to the dedicated AV/KVM gigabit switch.
Installation
Separate Mode
8
Advertisement
Table of Contents
