To Control The Source Over The Hp-Ib (Ieee 488.2); Procedure - HP 70427A User Manual

Getting Started

To Control the Source Over the HP-IB (IEEE 488.2)

To Control the Source Over the HP-IB (IEEE
488.2)

Procedure

Step 1 - Determine the sources HP-IB address
Look in the upper left corner of the display. The model number of the
module followed by its HP-IB address in parentheses should be displayed.
The two digits after the coma are the last two digits of the address.
Figure 2-39 HP-IB Address Location
For example, an HP 70428A with address 28 would display
. The complete HP-IB address for a computer with its
HP 70428A (0, 28)
HP-IB interface select code set to seven would be 728.
If the source doesn't respond to this address look on the MMS address map
to see if it has changed. if it has, cycling power or pressing the
key will reset the address to the number shown on the source
INSTR PRESET
screen.
HP 70427A/HP 70428A User's Guide 2-37