Table of Contents
Advertisement
Overview
Figure 1-26
Installation
Procedure B: Setting HP-IB Address
Procedure B: Setting HP-IB Address
The MS-IB address comes from the factory with the default set to '28'. This
also represents the HP-IB default address. if this location does not conflict
with any other module in your MMs, you do not need to change it.
Each module in the MMS system must have a unique HP-IB address. Check
the address map on the MMS to identify available address locations. If you
need to change the HP-IB address there are two ways to proceed:
I. You may temporarily change the HP-IB address using softkey
configurations (described in the HP mms mainframe Operation Guide)
II. You may change the MS-IB address switches which will also change
the HP-IB default address.
This procedure is described below:
1. The MS-IB row switches for the HP 70427A, HP 70428A, and the
HP 70428A Option 002 must be set to "zero" (because each of these
modules is a master in the system).
2. Set the column address to an available HP-IB address location, using
binary weighted value switches.
Address Switch Location
1-18 HP 70427A/HP 70428A User's Guide
or
Advertisement
Table of Contents
