Press The .05 Ppm/V , 1.0 Ppm/V , Or 20 Ppm/V - HP 70427A User Manual

Getting Started
To Output a Signal with a Microwave Source
Step 2 - Set the output power
A frequency must be shown in the
power entry will be accepted.
1. Press the
2. Press the
3. Key in the output power, dBm or mW, with the numeric keypad.
Power levels between 0 and +20 (100 mW), in 0.1 dB steps, can be
entered. But the minimum specified power is shown below.
Also, the actual resolution can be as much as 0.2 dB.
4. Press the
Figure 2-34 Output Power Softkey Locations
2-32 HP 70427A/HP 70428A User's Guide
Frequency:
softkey.
OUTPUT POWER
softkey.
POWER
•
2.4 to 6.6 GHz:+16
•
7.2 to 25.8 GHz: +10
or softkey.
dBm mW
display before an output