Table of Contents
Advertisement
Remote Programming Commands
HARDWARE CONTROL COMMANDS
These commands correspond to the
to set relays and latches in the module's hardware. The setting of these relays
and latches is normally invisible to the operator. See chapter 8 for a
description of how to use these commands and the
Table 12-9
HARDWARE CONTROL COMMANDS
Command
DIAG:BLOCK n
DIAG:BLOCK?
DIAG:LATC:DATA n
DIAG:LATC:DATA?
DIAG:LATC:NUMB n
DIAG:LATC:NUMB?
DIAG:MUX n
DIAG:MUX?
DIAG:REL:DATA n
DIAG:REL:DATA?
DIAG:REL:NUMB n
DIAG:REL:NUMB?
DIAG:VOLT?
12-10 HP 70427A/HP 70428A User's Guide
Hardwre Control
Function
Selects block n for control by the
LATC and MUX commands.
Returns the selected block.
Writes n to the selected latch.
Reads from the selected latch.
Selects latch n.
Returns the number of the selected
latch.
Selects multiplexer n.
Returns the number of the selected
multiplexer.
Sets the state of the selected relay
(normal: n=0 out: n=1).
Returns the state of the selected
relay.
Selects relay n.
Returns the number of the selected
relay.
Returns the voltage measured by
the internal voltmeter at the
selected multiplexer point.
softkeys. They are used
l softkeys.
Hardwre Contro
Equivalent Softkey or
Display
BLOCK
Block:
LATCH DATA
Data:
LATCH NUMBER
Latch:
VOLTMETER
Mux:
RELAY STATE
State:
RELAY NUMBER
Relay:
Volt:
Advertisement
Table of Contents
