Getting Started
To Output a Signal with a Microwave Source
To Output a Signal with a Microwave Source
Procedure
Step 1 - Set the Output Frequency
1. Press the
softkey.
Output
2. Press the
softkey.
FREQ
3. Key in a frequency between 2.4 GHz and 26.4 GHz with the numeric
keypad.
4. Complete the entry by pressing the appropriate units softkey.
The module's firmware will round off the entered frequency to the nearest
600 MHz. It will ignore frequencies outside the above range. The firmware
will also set the power to 0 dBm.
Figure 2-33
Microwave Source Signal Softkeys Locations
HP 70427A/HP 70428A User's Guide 2-31