Ieee 488.2 Common Commands - HP E1364A User Manual

IEEE 488.2 Common Commands

Command Title
*IDN? Identification
*RST Reset
*TST? Self-Test
*OPC Operation Complete
*OPC? Operation Complete Query
*WAI Wait to Complete
*CLS Clear status
*ESE Event status enable
*ESE? Event status enable query
*ESR? Event status register query
*SRE Service request enable
*SRE? Service request enable
query
*STB? Read status byte query
*TRG Trigger
*RCL Recall instrument state
*SAV Store instrument state
Note: These commands apply to many instruments and are not documented in detail here. See the
HP 75000 Series B E1300/E1301 Mainframe User's Manual or the ANSI/IEEE Standard 488.2-1987
for more information.
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The following table lists the IEEE 488.2 Common (*) Commands that apply
to the Form C Switch module. The operation of some of these commands is
described in Chapter 4 of this manual. For more information on Common
Commands, refer to the HP 75000 Series B Mainframe (HP Model Number
E1300/E1301) User's Manual or the ANSI/IEEE Standard 488.2-1987.
Description
Returns identification string of the switchbox
Opens all channels, and invalidates current channel list for
scanning. Sets ARM:COUN 1, TRIG:SOUR IMM, and
INIT:CONT OFF.
Always returns 0.
See note below
See note below
See note below
Clears all status registers (see
STATus:OPERation[:EVENt]?)
See note below
See note below
See note below
Enables status register bits (see Chapter 4 for operation)
See note below
See note below
Triggers the switchbox to advance the scan when scan is
enabled and trigger source is TRIGger:SOURce BUS
See note below
See note below
HP E1364A Form C Switch Command Reference 61