Ieee 488.2 Common Commands - HP E1361A User Manual

Command
*IDN? Identification
*RST Reset
*TST? Self-Test
*OPC Operation Complete
*OPC? Operation Complete Query
*WAI Wait to Complete
*CLS Clear status
*ESE Event status enable
*ESE? Event status enable query
*ESR? Event status register query
*SRE Service request enable
*SRE? Service request enable query
*STB? Read status byte query
*TRG Trigger
*RCL Recall instrument state
*SAV Store instrument state
Note: These commands apply to many instruments and are not documented in detail here. See the
Series B E1300/E1301 Mainframe User's Manual
488.2-1987 for more information.
60 Command Reference

IEEE 488.2 Common Commands

The following table lists the IEEE 488.2 Common (*) Commands that apply to the
relay matrix module. The operation of some of these commands is described in
Chapter 4 of this manual. For more information on Common Commands, refer to
the HP 75000 Series B Mainframe (HP Model Number E1300/E1301) User's
Manual or the ANSI/IEEE Standard 488.2-1987.
Title
Returns identification string of the switchbox.
Opens all channels, and invalidates current channel list for scanning. Sets
ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
Always returns 0.
See note below
See note below
See note below
Clears all status registers (see STATus:OPERation[:EVENt]?)
See note below
See note below
See note below
Enables status register bits (see Chapter 4 for operation)
See note below
See note below
Triggers the switchbox to advance the scan when scan is enabled and trigger source
is TRIGger:SOURce BUS
See note below
See note below
, the
Description
HP E1405A Command Module Manual
HP 75000
or the ANSI/IEEE Standard
Chapter 5