QMS 2060 Getting Started page 75

driver allows your QMS printer to take full advantage of all of these
features.
» Note: You cannot use the GX driver and the LaserWriter driver at the
same time.
To be able to use the GX drivers, you must have QuickDraw GX and
at least System 7.1 (preferably 7.5) installed on your Macintosh. See
your Macintosh documentation for more information.
» Note: To avoid losing any data, make sure you close any open files or
applications before installing the QMS GX driver, because the
Macintosh reboots when installation is complete.
Use the following instructions if you're installing the QMS GX printer
driver from the QMS Software Utilities CD-ROM.
» Note: At times updated printer drivers are shipped on 3.5" disk rather
than on CD-ROM. If your shipment includes a printer drivers on a 3.5"
disk, use the instructions in "Installing from a 3.5" Disk" on page 5-6
to install them.
1 Insert the CD-ROM in your CD-ROM drive.
2 If necessary, double-click the CD-ROM icon to display the
CD-ROM contents.
3 Double -click the MAC folder icon to display the folder con-
tents.
4 Double-click the GX folder icon to display the folder con-
tents.
5 Double-click the MAC_GX folder icon to display the folder
contents.
6 Double-click the gx_insta icon to open the Installer.