Page 3
Report any discrepancies to your QMS vendor. Don’t return any merchandise before contacting the vendor. QMS magicolor 2 CX controller board with 24 MB RAM installed See the installation instructions in this document. Anti-static wrist strap...
Page 4
Converting your QMS magicolor 2 DeskLaser to a QMS magicolor 2 CX Print System involves two steps: n n Removing the magicolor 2 DeskLaser controller board and installing the magicolor 2 CX controller board. Note: You’ll need a Phillips screwdriver for this procedure. »...
Page 5
DeskLaser controller board, and install them on the magi- color 2 CX controller board. The magicolor 2 CX control board comes standard with 24 MB of memory. It’s not necessary to add additional memory, but you may want to. Refer to the QMS magicolor 2 Options manual for SIMM removal and installation instructions.
Page 6
QMS magicolor 2, automatically prints. This indicates that the printer has successfully been converted from a QMS magicolor 2 DeskLaser to a QMS magicolor 2 CX Print System. Use the following illustrations to install the new dataplate and product...
Page 7
» Note: The dataplate illustrated here is for 110 volt printers. If you have a 220 volt printer, discard overlay P/N 1241202-001 (there is no FCC ID line on the dataplate). In addition, the Model name for 220 volt printers ends with a “-2” rather than a “-1.”...