QMS 2060 Getting Started page 62

1 In the Administration/Communications/Network2/CrownNet/
NetWare/Config PServer/File Srv Name[1], File Srv Name[2],
and File Srv Name[3] menus, enter the name of the target file
server (primary 3. x configuration server).
Note: The three File Srv Name[x] menus allow you to identify 1
»
file server with a name up to 47 characters long. (Up to 16
characters can be entered in each of the 3 menus). You cannot
use these 3 menus to identify 3 file servers. Up to 16 file servers
are supported. To enter the 15 other file server names, use
CrownAdmin 3.
Spaces and lowercase characters are not allowed within file
server names. However, underscore characters ( _ ) are allowed
to simulate multiword names (for example, PUBS_SERVER). At
the printer control panel only, a space must be used following the
last character of the file server name to end the name. For
example, the file server name
FIRSTGROUP_GROUPS_BLUE_TEAM_TEAMS_CRC_QMS
is 42 characters long, and must be entered as follows:
FILE SRV NAME[1]
FIRST_GROUP_GROU
FILE SRV NAME[2]
PS_BLUE_TEAM_TEA
FILE SRV NAME[3]
MS_CRC_QMS<space>
where <space> is the space character.
2 In the Administration/Communications/Network2/CrownNet/
NetWare/Config PServer/PServer Name[1], PServer Name[2],
and PServer Name[3] menus, enter the name of the bindery
print server.
Note: The three PServer Name[x] menus allow you to identify
»
one print server with a name up to 47 characters long. (Up to 16
characters can be entered in each of the 3 menus). You cannot
use these 3 menus to identify 3 print servers.