QMS 2060 Getting Started page 32

2 Position the cassette.
The cassette has a spring in the bottom that provides some resis-
tance when print media is placed on it. Lay the cassette flat on a
hard surface and, using your left hand, push down on the plate in
the cassette until it locks.
3 Load media in the 500-sheet cassette in increments so that
the 500 sheets fit in the cassette and the media stack is prop-
erly leveled out.
Load the media so the front end of the stack comes against the
front of the cassette in three steps as follows:
a Up to the bottom limit mark.
b Halfway to the top limit mark.