QMS 2060 Getting Started page 61

2 You're now ready to print.
From this point, you'll probably perform most printing tasks from
your application. For specific information, check the printing sec-
tion in your application documentation.
For information on print media types and sizes, see chapter 2,
"Print Media," in the Reference manual .
1 One unique printer name is broadcast to the network. Use
the Administration/Communications/Network2/CrownNet/
LAN Manager/Printer Name menu to enter the name of the
printer.
» Note: The name can be up to 16 characters long. Spaces and
lowercase characters are not allowed. Underscore characters
( _ ) are allowed to simulate multiword names (for example,
PRODUCT_MKTG).
2 You're now ready to print.
From this point, you'll probably perform most printing tasks from
your application. For specific information, check the printing sec-
tion in your application documentation.
For information on print media types and sizes, see chapter 2,
"Print Media," in the Reference manual .
Unless you want to use the default settings, use the following proce-
dure to name the file and print servers. These names must be unique.
» Note: In CrownAdmin, the printer shows up as QMS_xxxx_Print_
System_hardwareaddress, where xxxx is the printer model
number and hardwareaddress is the printer's hardware address as
found on the printer start-up page. This address will be blank until the
interface has been reset following installation.