QMS 2060 Getting Started page 65

1 In the Administration/Communications/Network2/CrownNet/
NetWare/Config PServer/PServer Context[1], PServer Con-
text[2], and PServer Context[3] menus, enter the name of the
configuration file server and print server context.
Note: The three PServer Context[x] menus allow you to identify
»
the name of the NDS configuration file server and the print server
context.
The format for the option is
File server name
Space
Print server context
For example, if the configuration file server name is QMS-4 and
the print server context is PRINTSERV2.SALES.QMS, you would
enter:
QMS-4 PRINTSERV2.SALES.QMS
Note: Make sure to put a space between the file server name
»
(QMS-4) and the print server context
( PRINTSERV2.SALES.QMS).
Up to 16 characters can be entered in the Pserver Context[1]
field, and additional 16 characters in Pserver Context[2] field, and
16 characters in the Pserver Context[3] field.
» Note: If you want to assign more than 14 characters to the file
server name you must use CrownAdmin 3 to enter the name.
2 Reset the CrownNet interface by using the Administration/
Communications/Network2/CrownNet/Common/Soft Reset
menu.
3 You're now ready to print.
From this point, you'll probably perform most printing tasks from
your application. For specific information, check the printing sec-
tion in your application documentation.
For information on print media types and sizes, see chapter 2,
"Print Media," in the Reference manual .