QMS 2060 Getting Started page 60

This section briefly describes the configuration procedure for the
CrownNet Ethernet printer interface. For a complete discussion of all
of the configuration options available through the Administration/Com-
munications/Network2/CrownNet menu, see chapter 2, "Interface
Configuration," of the QMS CrownNet System Administrator's Guide .
You can make these configuration changes through any of the follow-
ing means:
Printer control panel—For information on using the printer con-
trol panel to change configuration menu settings, refer to chapter
4, "Printer Configuration," of the Reference manual.
CrownAdmin (for DOS and Macintosh), CrownAdmin 3 (for
OS/2, AIX, HP-UX, Solaris/SunOS, and Windows/Windows
NT/Windows for Workgroups), or CrownNet Manager (for OS/
2)—For more information on using this software, refer to the
appropriate chapter in the QMS CrownNet System Administra-
tor's Guide or to the software's on-line help.
Remote Console—For information on accessing Remote Con-
sole, refer to the appropriate chapter in the QMS CrownNet Sys-
tem Administrator's Guide . For information on using Remote
Console, refer to the QMS Crown Remote Console User's Guide .
1 If your network has more than one zone, use the Administra-
tion/Communications/Network2/CrownNet/EtherTalk/Zone
Name/Zone Part 1 and Zone Part 2 menus to enter the name
of the zone to which the printer is attached.
» Note: The two Zone Part x menus allow you to identify 1 zone
with a name up to 32 characters long. (Up to 16 characters can
be entered in each of the two menus). You cannot use these two
menus to identify two zones. Trailing spaces are not considered
part of the zone name. All standard printable ASCII characters
are valid except the @ and ' symbols. The names are case
sensitive.