Performing A Pre-Installation Check; Locating The System; Grilles; Mounting The System - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

√ Does the condenser heat exhaust need to be ducted away? An optional kit is avail-
able.
√ Where to locate the thermostat, if remote interface control is ordered? Thermostat
should be located mid point on a wall within the wine cellar. Provides suffficient
access and exposure to airflow from the Wine Guardian system. The thermostat
should not be located under shelving or within racking.
√ Where to run the overflow drain line? Run to a field supplied drain location or
container
√ Are all the parts here to complete the installation? Installation sleeve, gasket , sealent,
fasteners

Performing a Pre-installation Check

√ Check for the properly sized breaker as dictated by the system rating plate data.
√ Is the cellar built with adequate insulation and vapor barriers? See the Wine Cellar
Design Guide at the Wine Guardian's web site www.wineguardian.com for more
information.

Locating the System

Wine Guardian systems are typically installed at the users eye level for ease of operation. The Through-
the-Wall system discharges warm air from its condenser end so this should be considered when deter-
mining the location for the system. Locating the system adjacent to a mechanical room or in close
proximity to an exterior wall may be required if ducting the warm condenser air is being considered.
The warmer condenser air can be ducted up to15 feet away.
Power Cord Location
As previously noted, the power cord is factory wired on the condenser side of the system. If you
require the cord on the wine cellar side for plugging into an available outlet, this can be accomplished
by removing the 3-wire leads (ground included) and moving the cord with connector to the opposite
side control bracket and wire nutting the black and white wires to the factory supplied loads. The wires
must have the terminations cut off and stripped first. Then screw the ground lead to the hole supplied
in the control bracket.
You must then move the voltage switch in the opposite direction as from the factory to move the
internal power to the cord on the wine cellar side.(See Illustrations)

Grilles

Factory supplied and installed for proper air intake and discharge for optimal system performance.

Mounting the System

Follow the steps on the following pages for installation of the Wine Guardian Through-the-Wall system
a "new" wine cellar installation.
17