Agilent Technologies InfiniiVision 6000 Series User Manual page 72

2 Front-Panel Controls
72
Run mode) then you are looking at the waveform data from the
last acquisition taken. See
base" on page 88.
19. Horizontal Menu/Zoom Key
models.) Press this key to access the menu where you can split
the oscilloscope display into Main and Zoom sections, and
where you can select XY and Roll modes. You can also select
horizontal time/division vernier and select the trigger time
reference point on this menu. See
base" on page 88.
20. Horizontal Sweep Speed Control
Horizontal section that is marked
speed. The symbols under the knob indicate that this control
has the effect of spreading out or zooming in on the waveform
using the horizontal scale. The horizontal sweep speed control
changes the time per horizontal division on the display. See
set up the Horizontal time base"
21. Measure Keys
Press the Cursors key to switch on cursors
that you can use for making measurements. Press the Quick
Meas key to access a set of predefined measurements. See
Chapter 5, "Making Measurements," starting on page 207.
22. Display
The display shows captured waveforms using a
different color for each channel. For more information about
display modes see Chapter
page 257. Signal detail is displayed using 256 levels of intensity.
For more information about viewing signal detail see
the intensity to view signal detail"
23. Entry Knob
The entry knob is used to select items from
menus and to change values. Its function changes based upon
which menu is displayed. Note that the curved arrow
symbol above the entry knob illuminates whenever the
entry knob can be used to select a value. Use the entry knob to
select among the choices that are shown on the softkeys.
"To set up the Horizontal time
(Labeled Main/Delayed on older
"To set up the Horizontal time
Turn the knob in the
to adjust the sweep
on page 88.
6, "Displaying Data," starting on
on page 263.
6000 Series Oscilloscope User's Guide
"To
"Varying