Agilent Technologies InfiniiVision 6000 Series User Manual page 64

2 Front-Panel Controls
C A U T I O N
64
Only connect USB devices to the USB host port. Do not attempt to
connect a host computer to this port to control the oscilloscope. Use
the USB device port if you want to connect a host (see the InfiniiVision
6000 Series Oscilloscope Programmer's Quick Start Guide for details).
7. Probe Compensation Terminals
terminals to match each probe's characteristics to the
oscilloscope channel to which it is connected. See
8. AutoProbe Interface
models.) When you connect a probe to the oscilloscope, the
AutoProbe Interface attempts to determine the type of probe
and set its parameters in the Probe menu accordingly. See
page 81. Note: Although the 100 MHz models lack the AutoProbe
interface, they do have a probe sense ring around the BNC.
Therefore, the probe attenuation factor will be automatically set
when you connect a compatible probe such as the 10073C or
10074C.
9. Channel Input BNC Connector
or BNC cable to the BNC connector. This is the channel's input
connector.
10. External Trigger Input
using an external signal. See
11. Trigger Output
This output is related to the oscilloscope's
internal trigger signal. See
12. Calibration Protect Switch
prevent unwanted re-calibration. See
13. 10 MHz Reference Input/Output
synchronizing multiple instruments, or you can output this
instrument's reference signal. See
14. XGA Video Output
the oscilloscope for viewing waveforms. See
Use the signal at these
(Not available on 100 MHz bandwidth
Attach the oscilloscope probe
Allows you to trigger the oscilloscope
page 136.
page 206.
Set this switch to "Protect" to
page
You can input a signal,
page 336.
You can connect an external display to
6000 Series Oscilloscope User's Guide
page 54.
105.
page 260.