Conventions; Graphic Symbols In Softkey Menus - Agilent Technologies InfiniiVision 6000 Series User Manual

Conventions

Graphic Symbols in Softkey Menus

6000 Series Oscilloscope User's Guide
Throughout this book, the front-panel keys and softkeys are
denoted by a change in font. For example, the Cursors key is in
the Measure section of the front panel. The Acq Mode softkey is
the left-most softkey when the Acquire menu is displayed.
In this manual, instructions for pressing a series of keys are
written in an abbreviated manner. Pressing the Utility key, then
the I/O softkey, then the Show I/O Config softkey is abbreviated
as follows:
Press Utility & I/O & Show I/O Config.
The following graphic symbols appear in the oscilloscope's
softkey menus. The softkey menus appear at the bottom of the
display, just above the six softkeys.
Use the Entry knob to adjust the parameter. The Entry knob
is located on the front panel. The
illuminated when this control is active.
Press the softkey to display a pop up with a list of choices.
Repeatedly press the softkey until your choice is selected.
Use the Entry knob labeled
adjust the parameter.
Press the softkey to display a pop-up menu. Press the softkey
or rotate and push the Entry knob to make an item active.
Option is selected but not active.
Option is selected and active.
Feature is on. Press the softkey again to turn the feature off.
Feature is off. Press the softkey again to turn the feature on.
Press the softkey to view the menu.
Press the softkey to return to the previous menu.
Front-Panel Controls
symbol above the knob is
and/or press the softkey to
2
67