Agilent Technologies InfiniiVision 6000 Series User Manual page 151

N O T E
6000 Series Oscilloscope User's Guide
5 Repeatedly press and release the Baud softkey to set the CAN
signal baud rate to match your CAN bus signal.
The CAN baud rate can be set to:
10 kb/s 50 kb/s
20 kb/s 62.5 kb/s
33.3 kb/s 83.3 kb/s
The default baud rate is 1 Mb/s
6 Repeatedly press and release the Smpl Pt softkey to select the
point between phase segments 1 and 2 where the state of the
bus is measured. This controls the point within the bit's time
where the bit value is captured.
One Bit
Sample Point
You can use the Zoom mode for easier navigation of the decoded
data.
If the setup does not produce a stable trigger, the CAN signal may be slow
enough that the oscilloscope is AutoTriggering. Press the Mode/Coupling
key, then press the Mode softkey to set the trigger mode from Auto to
Normal.
Triggering the Oscilloscope
100 kb/s 500 kb/s
125 kb/s 800 kb/s
250 kb/s 1 Mb/s
60%
70%
80%
4
151