Agilent Technologies InfiniiVision 6000 Series User Manual page 329

Saving and Printing Data 7
When the USB storage device is connected to the oscilloscope's
front or rear USB host port, a small four-color circle icon may be
displayed briefly as the USB device is read.
You do not need to "eject" the USB device before removing it.
Simply ensure that any file operation you've initiated is done,
and remove the USB drive from the oscilloscope's host port.
Do not connect USB devices that identify themselves as
hardware type "CD" because these devices are not compatible
with the 6000 Series oscilloscopes.
If two USB mass storage devices are connected to the
oscilloscope, the first one is designated "USB0" and the second
one is designated "USB5," not "USB1." This numbering method
is normal; it is inherent in the USB driver.
A file that has been deleted from the USB mass storage device
cannot be recovered by the oscilloscope.
Regarding USB Ports:
N O T E
The USB port on the front panel, and the USB port on the rear panel
labeled "HOST" are USB Series A receptacles. These are the receptacles
to which you can connect USB mass storage devices and printers.
The square receptacle on the rear panel labeled "DEVICE" is provided for
controlling the oscilloscope over USB. See the InfiniiVision 6000 Series
Oscilloscopes Programmer's Quick Start Guide or the InfiniiVision 6000
Series Oscilloscopes Programmer's Reference for more information. To
access these documents online, point your web browser to
www.agilent.com/find/mso6000 and select Library.
System software
System software files (software updates
which can be downloaded from
www.agilent.com/find/mso6000sw) can be loaded into the
oscilloscope. See "Software and firmware updates" on page 334
for more information.
6000 Series Oscilloscope User's Guide 329