Agilent Technologies InfiniiVision 6000 Series User Manual page 123

Bus values
can be
shown i n
hex or
binary
6000 Series Oscilloscope User's Guide
The buses are shown at the bottom of the display.
Using cursors to read bus values
To read the digital bus value at any point using the cursors:
1 Switch on Cursors (by pressing the Cursor key on the front
panel)
2 Press the cursor Mode softkey and change the mode to Hex or
Binary.
3 Press the Source softkey and select Bus1 or Bus2.
Viewing and Measuring Digital Signals 3
123