Agilent Technologies InfiniiVision 6000 Series User Manual page 157

6000 Series Oscilloscope User's Guide
Mode
Baud Rate
Specifying the VPT1000 LAN Address
This is necessary when the oscilloscope controls the VPT1000
(but not when a PC with J8130A Option 200 software controls
the VPT1000).
1 From the VPT1000 Menu, press the LAN Address softkey to
access the VPT1000 LAN Addresses Menu.
2 Enter the VPT1000's 4-byte IP address:
a Press the Value softkey and use the Entry knob to select a
byte value.
b Press the Next softkey to access the next byte.
3 When you have finished entering the IP address, press the
Apply softkey.
This is sufficient for connection via a hub or switch.
If the oscilloscope is connected directly to the VPT1000 (in a
point-to-point configuration), the following additional steps
must be taken.
Triggering the Oscilloscope
TDMA Struct
Channel
(Sync Mode)
FlexRay
trigger
VPT1000
Return to
LAN Address
previous menu
4
157