Table of Contents
Advertisement
Thermo Scientific
6.12 Embedding of Equipment
Embedding of Equipment
As soon as
As soon as additional equipment (pressure probe, feeder etc.) is plugged in a
socket
socket at the extruder base it will be displayed automatically
To operate the feeder via
To operate the feeder via the Overview page follow the steps below.
Touch the green input field right beneath the feeder icon to type in
1
the feeding rate.
Touch the grey feeder icon to start the feeder.
2
icon will change to green.
The red information field shows the actual feed rate during opera
The red information field shows the actual feed rate during operation.
Touch the green feeder icon to stop the feeder
3
feeder icon will change to grey.
See section
See section 6.7.1 on page 6-13 for additional information about the opera
tion of
tion of volumetric and gravimetric feeders.
Note:
Note:
Before starting the feeder it is necessary to run the extruder first
Before starting the feeder it is necessary to run the extruder first
Before starting the feeder it is necessary to run the extruder first.
To set the operating pressures via the Overview page follow
To set the operating pressures via the Overview page follow the steps
To set the operating pressures via the Overview page follow
below. When exceeding this pressure limit an alarm message appears.
below. When exceeding this pressure limit an alarm message appears.
below. When exceeding this pressure limit an alarm message appears.
(pressure probe, feeder etc.) is plugged in a
the Overview page follow the steps below.
green input field right beneath the feeder icon to type in
green feeder icon to stop the feeder. The color of the
for additional information about the opera-
Software Operations
Embedding of Equipment
automatically by a grey icon.
The color of the feeder
Process 11
6-27
Advertisement
Table of Contents
