Setting Up Pc Environment Variables; Before Beginning - Vatech Green 16 Installation Manual

8.

Setting Up PC Environment Variables

8.1

Before Beginning

Before setting PC environment variables, ensure that your PC and system are ready for
the procedure.
Checking PC BIOS Settings
Check the BIOS settings of your PC before starting the next step. The BIOS settings
must meet specifications in Appendix E: Checking PC BIOS Settings. If the BIOS
hasn't been set up in your PC or the settings are different from Appendix E, take the
steps below to configure the BIOS in your PC.
1. Reboot the PC and enter the BIOS setup untitly.
2. Go to Appendix E and set the variables as specified on the page.
Green 16/18 Installation Manual
8. Setting Up PC Environment Variables
Disregard this section in case the PC system is supplied with
the equipment. (The environment variables of the PC have
already been set on the PC.)
Ensure that the Emergency Stop Switch is off before

installing the InstallShield installation.
Do not install the programs irrelevant to image

acquisition and view on the same PC. There may be
subtle conflicts between them, leading to the
malfunction.
The PC system supplied with the equipment is intended

to be used as an image acquisition only. The PC server
for image management is strongly recommended to use
a different PC.
The programs related to the acquisition, viewing, and

manipulation of images should be installed on the
formatted PC, where no other program(s) except the
operating system (OS) is present.
Before InstallShield installation, ensure that the video

card driver installed on the PC is the most up-to-date
version. To check this, go to the website of the graphic
card manufacturer.
The "EnhancedHalt State (C1E)" option will be displayed
when you update the BIOS settings.
97