Setting Up Pc's Environment Variables; Before Beginning - Vatech Green 21 PCT-90LH User Manual

6.

Setting up PC's Environment Variables

6.1

Before Beginning

Checking PC BIOS Settings
The PC is shipped, with its BIOS settings, as specified in Appendix E: Checking PC
BIOS Settings. Before proceeding to the next sections, check the BIOS status.
In case the BIOS settings have not been configured in advance or the settings are
different, however, please follow the steps below.
1. Reboot the PC and go to BIOS setting mode.
2. Set the variables as in the table below.
Main Menu
Advanced
Advanced
Advanced
When you update the BIOS settings, "EnhancedHalt State (C1E)" option will be

displayed.
Green21 (Model: PCT-90LH) Installation Manual
6. Setting up PC's Environment Variables
Disregard this section in case the PC system is supplied with
the equipment. (The environment variables of the PC have
already been set on the PC.)
Ensure that the Emergency Stop Switch is in OFF

position prior to starting with the InstallShield installation.
Do not install the programs irrelevant to image acquisition

and view on the same PC. There may be subtle conflicts
between them, leading to the malfunction.
The PC system supplied with the equipment is intended

to be used as an image acquisition only. For the PC
server for image management, it is strongly
recommended to use a different PC.
The programs related to the acquisition, viewing and man

Insert the 3D viewer USBipulation of images should be
installed on the formatted PC, where no other program(s)
except the operating system (OS) is present.
Before InstallShield installation, ensure that the video

card driver installed on PC is the most up-to-date version.
To check this, go to the website of the graphics card
manufacturer.
PC BIOS default
Sub1 Menu
Power Options Runtime Power Management
Power Options
Power Options Enhanced Halt State (C1E)
Sub2 Menu
Idle Power Savings
Setup Value
[Disable]
[Normal]
[Disable]
63