Vatech Green 16 Installation Manual page 14

1. Introduction
6
Cautions for Installation
You must read and understand all instructions in this

manual before installing the equipment.
You must confirm that the system is installed according

to the instructions provided by this manual and perform
the appropriate procedures therein.
Before turning on the equipment, leave it a room

temperature for more than an hour
If the equipment has been stored at temperatures of

below 10℃ (50℉) for more than a couple of hours,
allow the equipment to reach room temperature before
applying mains voltage
Installation and related work must be performed by

people authorized by VATECH.
DO NOT connect any items or equipment that is not

part of this system: IEC60601-1-1 (3rd edition: 2005).
Any equipment not approved by VATECH must comply

with the applicable standards: IEC 60950-1 (2nd
edition: 2005) for IT equipment (Ex: PC) and IEC
60601-1 (3rd edition: 2005) for medical electrical
equipment.
All operators of this equipment must ensure that all

requirements outlined in IEC 60601-1-1 (3
2005): Safety Requirements for Medical Electrical
Equipment are fully met for the safety of patients,
operators, and the environment.
DO NOT touch-sensitive areas such as the sensor

when installing the equipment. The touch-sensitive
areas are mentioned in relevant sections.
The use of wireless phones may interfere with the

operation of this equipment.
Use an ESD (electrostatic sensitive device) wrist band

to connect it to a ground wire when installing the
equipment.
Touch a ground point to discharge static electricity

before handling PCB boards.
Important Notes for Installation Site
The PC monitor, emergency cut-off switch, and X-ray

Exposure Switch must be located close to the operator
edition:
rd
Green 16/18 Installation Manual