Installation and Operation Guide SOLECTRIA® PVI 25TL-208, PVI 50TL-480 and PVI 60TL-480
Use a No. 10 Hex wrench to remove the 4 screws between the inverter and the wiring box. Lift the
inverter enclosure and disconnect from the wiring box.
If the replacement inverter is to be installed immediately, skip this step and refer to section 3.2.5.2 for
installation of the inverter. Otherwise, use a No. 2 Phillips head screwdriver to remove the 2 screws on
the left side of the wiring box, and remove the bulkhead cover. Attach the cover on the connector of
wiring box.
DOCR-071030-A (10/7/2022)
Figure 8-4 Remove the Screws on Both Sides
Figure 8-5 Disconnect the Main Housing from the Wiring Box
Page 113 of 131