Electrical Connections; Power Supply; Road Safety Kit - Hardi NAVIGATOR Classic EAGLE 3000 Instruction Book

4 - Sprayer Setup

Electrical Connections

Power Supply

The power requirement is 12 V DC. Always note the polarity!
For proper function of the electric equipment for the sprayer, the tractor
must have the following sizes of electric wires and fuses installed.
SprayBox Connector, 1-pin Plug
The unit requires:
Wire 2.5 mm
Hydraulic control unit requires:
Wire 4.0 mm
Tractor must follow ISO 4165.
÷
NOTE! The delivered power connectors follow the standard of most modern tractors. If you have a tractor with
another power connector, it is necessary to disassemble the connector and fit it to the actual sprayer connector.
Contact your HARDI dealer.
÷
NOTE! The delivered connectors may vary on the sprayer, depending on its equipment and scope of supply.

Road Safety Kit

If rear lights are installed, connect the plug for rear lights to the tractor's
7-pin socket and check the function of rear lights, stop lights, side lights
and direction indicators on both sides before driving.
The wiring is in accordance with ISO 1724. See the chapter "Technical
Specifications" in this Instruction Book.
μ
ATTENTION! Turn OFF all work lights when driving on public
roads!
76
2
. Fuse 10 amps.
2
. Fuse 16 amps.
Traffic Light Connector, 7-pin Plug
The unit requires:
2
Wire 6x 1.5 mm + 1x 2.5 mm
The cable is custom made and must not
be changed to another type.
Tractor must follow ISO 1724.
2
.