Table of Contents
Advertisement
Liquid System
Pump
Diaphragm pump with 6 diaphragms, model 464.
Standard speed = 540 RPM (6-spline shaft).
Optional speed = 1000 RPM (21-spline shaft).
The design of the diaphragm pump is simple, with accessible
diaphragms and valves, which ensures that liquid does not contact the
vital parts of the pump.
Pump model 464 is shown in the picture.
TurboFiller
The TurboFiller is where you add the chemicals to be mixed with water in the MainTank.
Capacity: approximately 5 litres.
By operating the three levers (A) on the right side of the TurboFiller (B),
you can do the following:
• Stir up the added chemicals with water from the sprayer.
• Transfer the mix to the main tank.
• Clean your chemical container or the TurboFiller hopper (B) inside
by using the flushing nozzle.
• A spray gun (C) is also available for further cleaning.
Before Use
• Pull the handle to unlock.
• Grab the handle to pull the TurboFiller (B) down, until it click into locked position.
After Use
• Pull the handle to unlock.
• Pull the TurboFiller back in storing position, until it locks.
±
WARNING! Before releasing the lock, always keep a hand on the grip to avoid abrupt movement of the TurboFiller!
Rinsing of Chemical Containers
The upper lever is used for two purposes.
1. When the TurboFiller lid is open:
For rinsing empty containers. Place the container over the rotating
flushing nozzle in the middle of the TurboFiller to rinse the inside
of the container.
2. When the TurboFiller lid is closed:
Use the lever to rinse the hopper, when the filling of chemicals is
completed.
€
DANGER! Do not activate this lever, unless the multi-hole nozzle is covered by a container, as spray liquid may
otherwise hit the operator! Risk of injuries and spillage on the ground.
3 - Description
49
Advertisement
Table of Contents
