Electrical Connections; Power Supply - Hardi COMMANDER DELTA FORCE Instruction Book

4 - Sprayer Setup

Electrical Connections

Power Supply

Power requirement is 12 V DC. Always note polarity! For proper function
of the electric equipment, the wires must have the following
recommended cross sectional areas and correct fuses to ensure a
sufficient power supply.
The delivered power connectors follows the standard of most modern
tractors. If you have a tractor with another power connector, it is
necessary to disassemble the connector and fit it to the actual tractor
connector.
The number and the type of connectors may vary on the specific
sprayer, depending on its equipment.
Cigar connector, 1-pin
Spray control unit requires:
Wire 2.5 mm
Hydraulic control unit requires:
Wire 4.0 mm
JobCom connector, 3-pin
The unit requires:
Wire 6.0 mm
ISOBUS connector, 9-pin
The unit requires:
Wire 2 x 10 mm
+ 2 x (2 x 0.5 mm
The cable is custom made and must not be changed to
another type.
74
2
. Fuse 10 amps.
2
. Fuse 16 amps.
2
. Fuse 25 amps.
2 2
+ 2 x 2.5 mm
2
)
Traffic light connector, 7-pin
The unit requires:
2
Wire 6 x 1.5 mm + 1 x 2.5 mm
The cable is custom made and must not be
changed to another type.
Working light connector, 2-pin
The unit requires:
2
Wire 10.0 mm . Fuse 30 amps.
Power and data connector, 13-pin
Used for HC 6500 controller.
2