Table of Contents
Advertisement
Using the Drain Valve
Operate the drain valve from the ladder, just beside the main tank lid.
1. Pull the string to open the drain valve.
2. The valve is spring-loaded, but pulling the string upwards in the V-
shaped slit will keep it open.
3. To release, pull the string downward and the valve will close
automatically.
μ
ATTENTION! If draining residues, e.g. liquid fertilizer into a
reservoir, connect a snap coupler with hose to the drain valve, in
order to drain the liquid safely.
PressureEmpty (optional)
It is possible to drain to an external tank. This is done the following way:
1. Connect a hose from an external tank to the quick coupler on the
sprayer.
€
DANGER! Before setting pressure SmartValve to
important to ensure that the quick coupler lid is correctly and
completely fitted to the filling stud in its locked position. Failure
to do so causes a risk of contamination and injury from quick
coupler lid being "shot" off when pressurized! If it is not possible
to fit the lid completely, lubricate the rubber seal and the grip
hooks.
2. Turn the pressure SmartValve towards
3. Turn the suction SmartValve towards
4. Engage the PTO to start the pump.
μ
ATTENTION! Set pump RPM so that the pressure the connected
hose can handle is not exceeded.
5. When the tank is drained, then turn off the PTO again.
6. Disconnect the hose and fit the cap for the quick coupler.
BoomFlush - Manual Cleaning
When having the BoomFlush valves fitted to the end(s) of boom piping, the cleaning procedure is as follows:
1. Follow the cleaning procedure to clean the sprayer the first two times.
2. Open all BoomFlush valves by hand.
3. Continue the cleaning procedure to clean the sprayer for the third time.
4. Close BoomFlush valves.
±
WARNING! To prevent contamination of the soil, only open the BoomFlush valves at the last step of the cleaning!
, it is very
.
.
5 - Operation
111
Advertisement
Table of Contents
